GENESIS Wind & Power
Welcome to
GENESIS Wind & Power
My name is Bill Casey. I graduated from the original Sierra Nevada College at Lake Tahoe in 1988 at a time when SNC was the only private college with a science degree in alternative energy sciences (Energy Science), such as wind, solar, photovoltaic, hydroelectric, and the mechanics behind those sciences. The college also offered the science degree in environmental sciences and studies (Environmental Science) at that time. I was a dual major majoring in both. until the energy program ended in 1987 and my energy science courses were subsumed by the environmental science department. That said, after 37 years…
Wind Power has a new design
Meet GENESIS Wind & Power with its patent pending innovative method of increasing the power production of wind turbines. Based on an efficient design structure, output power generated is estimated to be greater than the input energy required.
GENESIS = Energy/Power Magnification
See below for how this is accomplished.
This is a one-page, scroll-down website
Questions? Comments? You can contact me directly at GenesisWindPower@gmail.com
William “Bill” Casey PO Box 2621 Sequim, WA 98382
https://youtu.be/bpepRaOmsOk?si=41buNKqSl88BgBo4
Click the above link to see the small-scale model below in ON mode
Law of the Conservation of Energy
The Law of Conservation of Energy states that energy can neither be created nor destroyed, although it may be transformed from one form to another. We agree with that law.
First Law of Thermodynamics
The First Law of Thermodynamics is the thermodynamic relation that, within an isolated system, the total energy of the system is constant, even if energy has been converted from one form to another. This Law is another way of stating the Law of Conservation of Energy. This is why perpetual energy in an isolated system can not exist. We agree with that law.
GENESIS is not an isolated system. Our magnification of energy employs two separate energy systems. We use one system to capture, convert and store electrical energy, and we use a second system to magnify that stored energy. How we do that is this: We start with what is called, “Free Energy,” energy derived from Earth’s natural available environmental source, the wind. That free energy is captured and converted into electric energy via wind turbine generators. The energy produced from those devices is then stored in batteries for later use elsewhere. This is System One of the two systems GENESIS uses. System One is a natural energy capture, conversion and storage system, and it provides the outside energy required to turn on System Two of the GENESIS magnification of energy system. In addition, System One is not limited to wind-derived energy; any controllable energy source will suffice.
System Two is a static, stand alone closed-loop wind tunnel with multiple vertical axis wind turbines (VAWTs) strategically located in its circular wall. These VAWTs capture the wind in the tunnel that is created with an air blower with the turbines’ wind capture sides while protecting their return sides from the wind force. Each VAWT is attached to an electric generator that sends its produced electric current to battery storage for use elsewhere. This System Two magnifies the free energy of System One for producing more energy than what was needed to create the wind in the wind tunnel via an electric blower. In other words, one watt in and potentially much more than one watt out.
Thank you for visiting. Please look closely at what follows for insight into construction and further possibilities.
What we believe is possible: The small-scale model shown at the top (the YouTube link) was created to visually validate the concept that by restricting airflow to a wind tunnel and applying the principles learned from the earlier wind catchers, a continuous flow of air in the tunnel can spin multiple wind turbines throughout the tunnel if set properly into the turbine tunnel’s exterior wall, as seen through the model’s transparent top.
If you have searched for information on the internet regarding free energy devices, environmental energy systems, wind energy turbines, vertical axis wind turbines, VAWT design, wind power conversion devices, free environmental energy sources, environmental energy devices, wind capture devices, wind turbine measurements in wind tunnels, wind tunnel experiments with wind turbines, or anything related to those concepts regarding wind power energy capturing, we believe this is different and has never been done before. Because if it had been done before, we would have seen examples of it somewhere in the world by now. We believe nobody thought of it yet, because they haven’t had the experience of inventing and building shielded VAWT wind catchers first. View the video clips, then read on for more information about this.
The above images represent a bird’s eye view of the turbine tunnel with multiple turbines embedded in its exterior wall, and a side-view of how the VAWTs’ return-side blades are shielded and enclosed on the turbine tunnel’s exterior wall.
When the blower inside the wind tunnel is turned on by the free energy that was captured in System One of the GENESIS energy magnification device, the wind speed and its wind force created in that tunnel can be controlled, which is the objective of the wind tunnel – the ability to take what is given to us freely from nature and bringing that natural wind force into a controlled indoor environment to best manage it for its optimal potential for all of the VAWTs in it. That essentially free wind power can go from a gentle breeze to a raging wind storm, depending on the strength and power requirements of its embedded VAWTs.
And, because those generators are sending their produced energy to no-load bearing batteries, they’re essentially operating freely and without restrictions of any kind. Any potential magnetic forces holding those generator shafts in place are readily overcome and vanquished when the wind is introduced to them
GENESIS 3.0 Spherical Vertical Axis Wind Turbine (VAWT) – the only successful spherical VAWT of its kind anywhere – with the wind shield-vane (with a much smaller vane, more of a rear fin) and a directly attached to its shaft a model DC generator attached to a red LED bulb, which can be seen lighting up when the turbine’s shaft rotates.
The GENESIS 4.0 Tower Wind Catcher model built in December 2022 above.
Below: First two early 2000 model prototypes of the wind shield-vane (with way too long vanes) protecting the return-sides of two out of three identical wind turbines demonstrating how they keep the turbines headed into the wind compared to the one identical turbine directly above the one in the foreground. As you can see in this loop, the one without the Windcatcher wind shield-vane doesn’t spin due to the forces of the wind on its return side.
Again, we start with Nature’s free energy that we captured in System One. In this example, we are using a high-powered wind machine that consumes 200 watts per hour and can create wind speeds in excess of 250 miles per hour at its front end, a speed far much faster than required to spin a VAWT at its optimum speed and power potential. The wind force created travels through a circular wind tunnel that has only four VAWTs in it, with each VAWT attached to a 200 watt generator. When all four VAWTs are spinning at their optimum power potential, whatever that wind speed may be, they create a combined 800 watts of power output.
The result is 200 watts in from System One and 800 watts out from System Two, with a net gain of 600 watts.
The GENESIS 3.0 Spherical Windcatcher and 4.0 Tower Windcatcher prototype models
So here we are with the question: Can this be done?
We here at GENESIS Wind & Power would very much like to see others here in the United States and elsewhere in the world explore for themselves the possibilities of the GENESIS Turbine Tunnel by constructing one. If you are in another country and you succeed in creating one that works as claimed, please let us know, and feel free to patent that in your country. Our patent is protected here in the U.S. and we welcome global kinship in the mutual goal of creating a better world through environmentally safe and sustained energy production to meet the increasing global demand for it.
As you can see, the turbine tunnel is a closed-loop, circular tunnel shaped like a donut. The only air in that tunnel is the only air that the blower/fan, or an axial flow compressor, has to work with. No air leaves the turbine tunnel and no air enters it from the outside. This means that all of the air being blown in the tunnel by the front of the fan device installed in that wind tunnel comes from the available air behind it, assuring no diminishment of wind speed throughout the tunnel. Here’s an example of how that works: if you have a shop vac with a hose, you know it can be either a blower or a vacuum depending on where you attach the hose. Take the hose and attach it to both the shop vac’s air in and air out, and turn it on. The motor runs real smooth.
Because the returning side of a typical VAWT struggles to overcome the wind force against that side while attempting to capture the wind force on its other, we embed that VAWT turbine’s return side into the wall so to allow the wind to hit only its capture side. This way, the VAWT can operate close to its optimum potential without resistance from that wind. If constructed properly, multiple VAWTs can be installed in that wind tunnel’s wall, with each VAWT attached to an electrical generator.
GenesisWindPower@gmail.com
Questions? You can contact me directly at GenesisWindPower@gmail.com
William “Bill” Casey
GENESIS Wind & Power 